The Township of Riverside is divided into the following 12 districts:[1]
|
Residential - 1 (R-1)
|
|
Residential - 2 (R-2)
|
|
Residential - 3 (R-3)
|
|
Residential - 4 (R-4)
|
|
Flood Hazard Conservation (FH-C)
|
|
Special Development - 1 (SD-1)
|
|
Special Development - 2 (SD-2)
|
|
Special Development - 3 (SD-3)
|
|
Special Development - 3 (SD-4)
|
|
Commercial District (CD)
|
|
General Industrial - 1 (I-1)
|
|
Commercial Industrial - 2 (I-2)
|
[1]
Editor's Note: Map that delineates each district is contained
in Appendix D.
The boundaries of the zoning districts are set forth on a map
entitled "Zone Map, Township of Riverside, NJ," a reduced size copy
of which is contained herein as Appendix D and is made part of this
chapter. The Zone Map is on file in the office of the Township Clerk.
A.
Zoning district boundary lines are intended to follow street center
lines, railroad rights-of-way, streams and lot or property lines as
they exist on lots of record at the time of the enactment of this
chapter, unless otherwise indicated by dimensions on the Zone Map.
B.
Where on the Zone Map a district boundary is located approximately
along a street or alley line or along a lot line, the center line
of such street or alley or such lot line shall be construed to be
the boundary.
C.
The exact location of any disputed zoning district boundary line
shall be determined by the Joint Land Use Planning Board.
D.
The zoning standards, controls and designations apply to every structure,
lot and use within each district, and the district lines extend vertically
in both directions from the ground level.
