In addition to the general requirements of Article IV, the requirements of this section apply to all development proposed in special flood hazard areas.
In areas of shallow flooding (Zone AO), the lowest floor (including
basement) shall be elevated at least as high above the highest adjacent
grade as the depth number specified in feet on the Flood Insurance
Rate Map plus 12 inches, or at least two feet if a depth number is
not specified; adequate drainage paths shall be provided to guide
floodwaters around and away from the structure.
Enclosures below the lowest floor (including crawl spaces) shall
be provided with flood openings which shall meet the following criteria
(see FEMA Technical Bulletin No. 1, Openings in Foundation Walls and
Walls of Enclosures):
There shall be a minimum of two openings on different sides
of each enclosed area; if a building has more than one enclosed area
below the base flood elevation, each area shall have openings on exterior
walls.
The total net area of all openings shall be at least one square
inch for each square foot of enclosed area, or the openings shall
be designed and certified by a registered engineer or architect to
provide for equalization of hydrostatic flood forces on exterior walls
by allowing for the automatic entry and exit of floodwaters.
Where installed in doors and windows, openings that meet requirements of § 78-27B(3)(a) through (d) are acceptable; however, doors and windows without installed openings do not meet the requirements of this section.
Crawl spaces shall have the finished interior ground level equal
to or higher than the outside finished ground level on at least one
entire side of the foundation wall.
Be elevated on a permanent, reinforced foundation that raises the lowest floor to or above the base flood elevation plus 12 inches and is otherwise in accordance with § 78-27A.
Be installed in accordance with the anchor and tie-down requirements
of the building code or the manufacturer's written installation
instructions and specifications.
For the purpose of this requirement, the lowest floor of a manufactured
home is the bottom of the lowest horizontal supporting member of the
lowest floor.
The lowest floor (including basement) shall be elevated to or above the base flood elevation plus 12 inches or the structure shall be dry floodproofed in accordance with § 78-28B.
In areas of shallow flooding (Zone AO), if not dry floodproofed,
the lowest floor (including basement) shall be elevated at least as
high above the highest adjacent grade as the depth number specified
in feet on the Flood Insurance Rate Map plus 12 inches, or at least
two feet if a depth number is not specified; adequate drainage paths
shall be provided to guide floodwaters around and away from the structure.
Be designed to be dry floodproofed such that the structure is watertight
with walls and floors substantially impermeable to the passage of
water to the level of the base flood elevation plus 12 inches. In
areas of shallow flooding (Zone AO), the structure shall be dry floodproofed
at least as high above the highest adjacent grade as the depth number
specified in feet on the Flood Insurance Rate Map plus 12 inches,
or at least two feet if a depth number is not specified.
Be certified, by a licensed professional engineer or licensed professional
architect with a floodproofing certificate, that the design and methods
of construction meet the requirements of this section. Refer to FEMA
Technical Bulletin No. 3, Non-Residential Floodproofing - Requirements
and Certification, for guidance.
Accessory structures shall meet the requirements of these regulations.
Accessory structures that have a footprint of no more than 200 square
feet may be allowed without requiring elevation or floodproofing,
provided such structures meet all of the following requirements:
Within any floodway area designated on the Flood Insurance Rate Map,
no encroachments, including fill, new construction, substantial improvements,
or other development, shall be permitted unless it has been demonstrated
through hydrologic and hydraulic engineering analysis that the proposed
encroachment would not result in any increase in flood levels within
the community during the occurrence of the base flood discharge. Such
technical data shall be submitted to the Floodplain Administrator
and to FEMA. The analyses shall be prepared by a licensed professional
engineer in a format required by FEMA for a conditional letter of
map revision or letter of map revision. Submittal requirements and
processing fees shall be the responsibility of the applicant.
Will result in an increase in the base flood elevation, provided
a conditional letter of map revision has been issued by FEMA and the
applicant completes all of the following:
Documents that individual legal notices have been delivered
to all impacted property owners to explain the impact of the proposed
action on their properties;
Requests and receives concurrence of the Mayor of Middletown
and the Chief Executive Officer of any other community impacted by
the proposed actions; and
For development activities in a special flood hazard area with base
flood elevations but no designated floodways, the applicant shall
develop hydrologic and hydraulic engineering analyses and technical
data reflecting the proposed activity and shall submit such analyses
and data to the Floodplain Administrator and to FEMA. The analyses
shall be prepared by a licensed professional engineer in a format
required by FEMA for a conditional letter of map revision or letter
of map revision. Submittal requirements and processing fees shall
be the responsibility of the applicant.
The proposed development activity may be permitted if the analyses
demonstrate that the cumulative effect of the proposed development
activity, when combined with all other existing and potential special
flood hazard area encroachments, will not increase the base flood
elevation more than 1.0 foot at any point.
For the purpose of these regulations, a watercourse is deliberately
altered when a person causes a change to occur within its banks. Deliberate
changes to a watercourse include, but are not limited to: widening,
deepening or relocating of the channel; installation of culverts;
construction of bridges; and excavation or filling of the channel
or watercourse banks.
For any proposed deliberate alteration of a watercourse, the applicant
shall develop hydrologic and hydraulic engineering analyses and technical
data reflecting such changes and submit such technical data to the
Floodplain Administrator and to FEMA. The analyses shall be prepared
by a licensed professional engineer in a format required by FEMA for
a conditional letter of map revision or letter of map revision. Submittal
requirements and processing fees shall be the responsibility of the
applicant.
Documentation of compliance with § 78-30A if the alteration is in a floodway or § 78-30B if the alteration is in a watercourse with base flood elevations but no floodway.
Evidence that adjacent communities, the United States Army Corps
of Engineers, and the Delaware Department of Natural Resources and
Environmental Control (Division of Watershed Stewardship) have been
notified of the proposal and evidence that such notifications have
been submitted to the Federal Emergency Management Agency.
Evidence that the applicant shall be responsible for providing
the necessary maintenance for the altered or relocated portion of
the watercourse so that the flood-carrying capacity will not be diminished.
The Floodplain Administrator may require the permit holder to enter
into an agreement with the Town of Middletown specifying the maintenance
responsibilities; if an agreement is required, the permit shall be
conditioned to require that the agreement be recorded on the deed
of the property which shall be binding on future owners.