The final plat of the subdivision shall comply
with the following requirements and contain the following information.
The following graphic information shall be provided:
A. Boundaries: exact boundaries of the area included
within the subdivision, with dimensions to hundredths of a foot and
bearing to half minutes. These boundaries shall be determined by an
accurate survey in the field in accordance with minimum standards
for practice for boundary surveys as defined in 09.13.03.00, Title
9 Department of Labor, Licensing, and Regulation Subtitle 13 Board
for Professional Land Surveyors Chapter 3 Survey Markers Authority:
Business Occupations and Professions Article, § 15-208,
Annotated Code of Maryland. Coordinates must be shown at all boundary
break points.
[Amended 10-9-2018 by Ord. No. 2018-08]
B. Bearings and distances: bearings and distances to
the nearest recorded property corners or other monuments, which shall
be located or accurately described on the plat.
C. Monuments: the accurate location and descriptions
of all permanent monuments. Where applicable and feasible the coordinates
of all permanent markers or monuments should be based on the Maryland
Coordinate System.
[Amended 10-9-2018 by Ord. No. 2018-08]
D. Adjoining owners: names and locations of adjoining
subdivisions and the locations and ownership of adjoining unsubdivided
property.
E. Adjoining roads: exact locations, width, and name
of each existing or recorded road or street adjoining or intersecting
the boundaries of the tract.
F. Engineering data: the exact location and width of
every road, street, alley, easement, or other public or private way
within the tract, with the length and bearing of every tangent, length
of arcs, radii, delta angle, tangent, chord length, chord bearings
and any other necessary engineering data; with the names of such ways,
and the purpose of easements or other ways; accurate location of every
lot line, with its dimension to hundredths of a foot and bearings
to half-minutes, except that this data need not be repeated on a series
of parallel lines or lines of the same length.
G. Setback lines: minimum building setback lines (front,
side, rear) on all lots and other sites.
H. Numbering: blocks lettered in alphabetical order,
and lots numbered in numerical order.
I. Public lands: accurate outlines or any areas dedicated
or reserved for public use, or for any other purpose except sale,
with the purpose indicated.
J. Lot area: accurate area of each lot or parcel, other
than public ways.
K. Municipal lines: accurate location of any municipal
or district line traversing or closely related to the tract.
L. Drainage lines: existing and relocated courses of
any watercourses or storm drainage facilities traversing the tract,
with the right-of-way or easement lines provided therefor.
M. Water and sewer lines: the location and size of all
existing and proposed water and sewer lines.
The following certificates and other information
shall be provided:
A. Owner's certificate: owner's certificate, signed and
notarized, acknowledging ownership of the property and agreeing to
the subdividing thereof as shown on the plat; also offering for dedication
all streets and other ways and places intended for public use.
B. Surveyor's certificate: certificate of the surveyor
to the effect that the plat represents a survey made by him, that
it is accurate to the best of his knowledge, and that all survey markers
indicated thereon actually exist and their locations and descriptions
are correctly shown, and that all requirements of this chapter and
of other applicable laws have been fully complied with.
[Amended 10-9-2018 by Ord. No. 2018-08]
C. Agency approvals. A space shall be provided for a
certificate of approval by Myersville Planning Commission. The plat
must also contain a space for approval of the Frederick County Health
Department with the required Health Department statement on conformance
with the County Master Water and Sewer Plan and a statement signed
by the owner that all lots offered for sale will be serviced by public
water and public sewerage.
[Amended 10-9-2018 by Ord. No. 2018-08]
D. Protective covenants. Protective covenants which apply
to all the area as shown by the recorded plat shall be part of the
recorded plat.