Town of Rhinebeck, NY
Dutchess County
By using eCode360 you agree to be legally bound by the Terms of Use. If you do not agree to the Terms of Use, please do not use eCode360.
Table of Contents
Table of Contents
[HISTORY: Adopted by the Town Board of the Town of Rhinebeck 6-27-1988.[1] Amendments noted where applicable.]
GENERAL REFERENCES
Environmental quality review — See Ch. 68.
Flood damage prevention — See Ch. 73.
Streets and sidewalks — See Ch. 96.
Subdivision of land — See Ch. 101.
Zoning — See Ch. A136.
076a Table 1076b Appendix B Figures
[1]
Editor's Note: The introduction to these standards read as follows:
"The purpose of these specifications and regulations is to establish minimum acceptable uniform standards for street and highway construction, including but not limited to such items as street and highway classification, geometrics, design, drainage, construction requirements for road base and pavement, curbs and sidewalks, monuments and signs.
"These specifications, along with referenced New York State Department of Transportation Standard Specifications, should govern most situations or conditions encountered with respect to street and highway planning and construction. Interpretation of these specifications is the sole responsibility of the Town Highway Superintendent, the designated Town Engineer and, when applicable, the Town Planning Board, with specific approval required from these persons for any deviations in procedures and materials mentioned in these specifications.
"Application of these specifications to recognized engineering principles and acceptable construction practices should provide a basis for efficient and orderly growth in the Town street and highway system and for the satisfactory provision of access within subdivisions within the Town of Rhinebeck."
Article I General Provisions
Article II Street and Highway Classifications
Article III Construction Specifications
Article IV Drainage Specifications
Article V Subgrade; Grading; Foundation Course
Article VI Street and Highway Pavement
Article VII Additional Design Requirements
Article VIII Other Requirements