A. 
Each SUBDIVIDER shall file with the BOARD three black-and-white copies of a preliminary PLAN at a horizontal scale of one inch to either 20 feet, 40 feet, 50 feet or 100 feet and a vertical scale of not more than 40 feet to the inch. The overall sheet size shall be 24 inches by 36 inches, with separate sheets numbered and showing their relationship to each other by means of match marks. A margin of at least one inch shall be provided outside ruled border lines on three sides and of at least two inches along the left side for binding.
B. 
The preliminary PLAN shall show or be accompanied by the following information:
(1) 
Proposed SUBDIVISION name, signature and address of OWNER of record, signature of SUBDIVIDER and engineer or surveyor, date and North point and scale.
(2) 
Names of OWNERs of record abutting properties certified by the Selectmen[1] on Form B (see Appendix[2]), abutting SUBDIVISION names, streets, easements, setbacks, alleys, parks and public open spaces and similar facts regarding abutting property.
[1]
Editor's Note: The certified list of abutting OWNERs of record may be obtained from the Assessor's Office.
[2]
Editor's Note: The appendix is available and on file in the Town offices.
(3) 
Location of property lines and their approximate dimensions; existing easements, buildings, watercourses, ponds or standing water, rock ledges and other essential features.
(4) 
Existing water mains, sewers, culverts, drains and proposed connections or alternative means of providing water supply and disposal of sewage and surface drainage; location of each percolation test hole and the results, each proposed septic tank and drainage field, each proposed well and typical designs of proposed on-LOT water and sewerage systems. A certificate of approval from the Board of Health of the TOWN OF HUDSON[3] shall be required when on-LOT utilities must be installed.
[3]
Editor's Note: Approval is required from the state for on-LOT utilities.
(5) 
Location, name and RIGHT-OF-WAY widths of existing and proposed streets and HIGHWAYs within the SUBDIVISION and on abutting land within 200 feet, along with their grades and profiles, and the elevations of sufficient points on the property to indicate the general topography of the property. For land that slopes less than approximately 2%, spot elevations at all breaks in grade, along all drainage channels or swales and at selected points not more than 100 feet apart in all directions; for land that slopes more than approximately 2% either contours with an interval of not more than five feet, if ground slope is regular, or not more than two feet, if ground slope is irregular. If any of the aforesaid features cannot be so indicated on the primary drawing, an additional sheet drawn to a scale of 100 feet to the inch or 200 feet to the inch shall be submitted to satisfy the requirements of this section. Aerial photography or Town topographic mapping which suitably depicts the aforementioned features and properly identifies the tract may be used for this purpose.
(6) 
Proposed LOTs, approximate square foot size of each LOT and setback lines. House numbers shall be assigned as directed by the Board of Selectmen and shown on the final plat.[4]
[4]
Editor's Note: House numbers are assigned by the Fire Department. For related provisions, see Ch. 281, Street Numbering.
(7) 
Location of all parcels of land proposed to be dedicated to public use and the conditions of such dedication, and a copy of such private deed restrictions as are intended to cover part or all of the tract.
(8) 
Preliminary designs of any bridges or culverts which may be required.
(9) 
Where the preliminary PLAN submitted covers only a part of the subdivider's entire holding, a sketch of the prospective future STREET system of the unsubmitted part shall be furnished, and the STREET system of the submitted part shall be considered in the light of adjustments and connections with the STREET system of the part not submitted.