Where a new driveway or a driveway for a new dwelling will exceed
500 feet in length from a public street or private way to any dwelling
located on any lot, said driveway shall meet the following minimum
standards:
A. Minimum width - said driveway shall have a minimum width of 14 feet
with a minimum ten-inch gravel base and a top surface of either gravel
or bituminous concrete or combination of both.
[Amended 4-25-2023 ATM
by Art. 22]
B. Minimum weight bearing - the Director of Public Works shall approve
the minimum weight bearing capacity as certified by a registered professional
engineer of all such driveways at such locations where the driveway
shall consist of a bridge or shall have located under it any culverts
or pipes for the purpose of water flow.
C. Vertical clearances - all overhead utilities or structures of any
kind shall have minimal vertical clearance above said driveway of
15 1/2 feet.
D. Turnaround - all said driveways shall be constructed with a maintained
turnaround area or circular turnaround, in proximity to the dwelling
as may be approved by the Director of Public Works.
E. Maximum grades and minimum radii - said driveway shall be constructed
with maximum grade slopes of no more than 8% and minimum turning radii
in all locations of not less than 40 feet.
F. Other conditions - all applicants for such driveway permits shall
submit suitable plans to the Director of Public Works for approval,
who may impose such conditions in said permit as will reasonably assure
access to and from said public street or private way to any dwelling
built on the property of the applicant for the purpose of assuring
access to such structures of all public safety services.
G. Waivers - the Director of Public Works shall waive any of the requirements
of this section in a given case upon written request by the Planning
Board.
This chapter shall not apply to any driveway in existence upon
the effective date hereof or to any repair or replacement thereof.