[Adopted by L.L. No. 5-1992 (Sec. 640 of the 1996 Code)]
A. 
The purpose of this article is to safeguard potable public water supplies from potential contamination by preventing backflow from a water user's system into the public water system. It is the intent of this article to recognize that there are varying degrees of hazard and to apply the principal that the degrees of protection should be commensurate with the degrees of hazard. Further, it is the intent of the Village of Dryden, New York, to comply with the requirements of New York State Sanitary Code, Part 5, Section 5-1.31, which said section mandates the requirement that the supplier of water protect their water system in accordance with procedures acceptable to the Commissioner of Health. These mandated requirements are as set forth in the Cross-Connection Control Manual published by the New York State Department of Health (NYSDOH) and to that extent, the terms, conditions and provisions of the New York State Sanitary Code, Part 5, Section 5-1.31 and the Cross-Connection Control Manual are incorporated in this article by reference as if more fully stated.
B. 
It is further the intent of the Village to comply with future changes, addendums, and guidelines to said code and manual.
As used in this article, the following terms shall have the meanings indicated:
ACCEPTABLE CHECK VALVE
A check valve that seats readily and completely. It must be carefully machined to have free moving parts and assured watertightness. The face of the closure element and valve seat must be bronze, composition, or other noncorrodible material which will seat tightly under all prevailing conditions of field use. Pins and bushings shall be of bronze and other noncorrodible, nonsticking material, machined for easy, dependable operation. The closure element shall be internally weighted or otherwise internally equipped to promote rapid and positive closure in all sizes where this feature is obtainable.
ACCEPTABLE DOUBLE-CHECK VALVE ASSEMBLY
Two single independently acting check valves, including tightly closing shutoff valves located at each end of the assembly and suitable test connections. This device must be acceptable as a complete assembly. Reference is hereby made to the "Technical References of the Environmental Health Manual" as published by the New York State Department of Health.
ACCEPTABLE REDUCED PRESSURE ZONE DEVICE
A minimum of two independently acting check valves together with automatically operated pressure differential relief valve located between the two check valves. In case of leakage of either check valve, the differential relief valve, by discharging to the atmosphere, shall operate to maintain the pressure between the checks at less than the supply pressure. The unit must include tightly closing shutoff valves located at each end of the device, and each device shall be fitted with properly located test cocks. This device must also be acceptable as a complete assembly. Reference is hereby made to the "Technical References of the Environmental Health Manual" as published by the New York State Department of Health.
AIR GAP SEPARATION
A physical break between a supply pipe and a receiving vessel. The air gap shall be at least double the diameter of the supply pipe, measured vertically above the top rim of the vessel, but in no case less than one inch.
APPROVED WATER SUPPLY
Any water supply approved by the New York State Department of Health.
CERTIFIED BACK FLOW PREVENTION DEVICE TESTER
An individual who has successfully completed a New York State Department of Health approved course in the testing of back flow prevention devices and has been issued a certificate by the New York State Department of Health.
CROSS-CONNECTIONS
Any unprotected connection between any part of a water system used or intended to be used as a supply of water for drinking purposes in a source or system containing water or substance that is not or cannot be approved as equally safe, wholesome and potable for human consumption.
SUPPLEMENTARY WATER SUPPLY
Any water supply on or available to the premises other than an approved public water supply.
VACUUM BREAKER, PRESSURE-TYPE AND NON-PRESSURE-TYPE
A vacuum breaker which can only be used for internal plumbing control and, therefore, is not acceptable as a containment device.
WATER USER SUPERVISOR
The consumer or a person on the premises charged with the responsibility of complete knowledge and understanding of the water supply piping within the premises and for maintaining the consumer's water system free from cross-connections and other sanitary defects, as required by this article and all other required regulations and laws.
A. 
Where protection is required. All water system users within the Village of Dryden shall be required to maintain a degree of protection commensurate with the degree of hazard regardless of whether the hazard is immediate or potential. To that extent, the Cross-Connection Control Manual published by NYSDOH shall be used as a guide to determine where protection is required. It shall be the responsibility of the water user to provide and maintain such required protection devices, and such devices shall be of a type acceptable to the New York State Department of Health.
B. 
Type of protection. The protective device required shall depend on the degree of hazard as tabulated below:
(1) 
At the service connection to any premises where there is a supplementary water supply handled in a separate piping system with no known cross-connection, the public water supply shall be protected by an acceptable reduced pressure zone device.
(2) 
At the service connection to any premises on which a substance that would be objectionable (but not necessarily hazardous to health if introduced into the public water supply) is handled so as to constitute a cross-connection, the public water supply shall be protected by an acceptable double-check valve assembly.
(3) 
At the service connection to any premises on which a substance of unusual toxic concentration or danger to health is or may be handled, the public water supply shall be protected by an air gap separation or an acceptable reduced pressure zone backflow prevention device. If an air gap is installed, it shall be located as close as practical to the water meter, and all piping between the water meter and receiving tanks shall be entirely visible. A reduced pressure zone device, when installed, shall be located as close as possible to the property line.
(4) 
At the service connection to any sewage treatment plant or sewage pumping station, the public water supply shall be protected by an acceptable reduced pressure zone backflow prevention device and it shall be located as close as possible to the property line.
C. 
Frequency of inspection of protective devices. It shall be the duty of the water user on any premises where backflow protective devices are installed to have competent inspections made at least once a year, or more often in instances where successive inspections indicate repeated failure. Devices shall be repaired, overhauled or replaced at the expense of the water user whenever they are found to be defective. These tests shall be performed by a qualified backflow prevention device tester and all test results will be provided to the Village within 72 hours after the test is made. Records of such tests, repairs and overhaul shall also be kept and made available to the water user and the local Health Department upon request.
A. 
No water service connection to any premises shall be installed or maintained by the water user, unless the water supply is protected as required by this article and such other applicable local, state and federal laws, rules and regulations.
B. 
Service of water to any premises may be discontinued by the Village if a backflow prevention device required by this section and regulations is not installed, tested and maintained; if any defect is found in an installed backflow prevention device; if it is found that a backflow prevention device has been removed or bypassed; or if unprotected cross-connections exist on the premises, and service will not be restored until such conditions or defects are corrected.
C. 
Village Water Department personnel shall be allowed access to premises of water users for the purpose of determining the need for and compliance with the provisions of this article. If any facility served by the Village's water system denies a Village Water Department person access to their premises for the purposes of determining if protection to the public water system is necessary, then the maximum protection condition shall be imposed with the requirement that the number of devices shall equal the number of service lines.
D. 
Failure to comply with any of the provisions of this section shall be deemed a violation and the violator shall be punished as set forth on the Village of Dryden Fine Schedule, which Fine Schedule may be established by resolution and thereafter amended from time to time by resolution of the Village Board of Trustees.
[Amended 4-10-2014 by L.L. No. 3-2014]
The Board of Trustees of the Village of Dryden is authorized to adopt such rules and regulations as may be appropriate to carry out the purpose and intent of this article.
A. 
The provisions as set forth herein shall apply immediately upon the effective date of this article to all water users commencing or renewing service on or after that date. No building permit for new construction shall be issued without compliance with the provisions of this article and such other applicable local, state and federal laws, rules and regulations.
B. 
The provisions as set forth herein shall apply six months after the effective date of this article to water users who have commenced service prior to the effective date of this article. Notwithstanding the above, the Village may require immediate compliance with all provisions of this article (and may terminate service) in the event a hazard of contamination of the public water system from the facility of an existing user is determined to exist.